Poolside Concrete or Paver Mount Umbrella/Shade Kit
A great way to accent your pool and provide shade just where you need it!
Choose from either a "Concrete Solid Surface" mount style or a "Paver Mount" style, install the low profile (3/8" high) sleek (5" diameter) mount anywhere on your pool deck (near pool edge for over water shade). When not in use the mounts won't get in your way, but can be used with the quick release bracket to set up your shade in seconds. Kit includes all hardware and drill bit/s for mounting.
Angled shade bracket and patents pending features of the Bahu Brand mounts and accessories allow you to easily rotate the bracket to direct shade where you want it. When done, easily remove the bracket and store.
Includes a 6.5 foot lightweight umbrella and storage bag. Umbrella has tilt function to match the angle of the umbrella bracket. Choose from a variety of colors. (Umbrella ships separately)
The Paver Mount Style is simple to install (just drilling two holes through a paver with the masonry drill bits provided and then pounding the mount pins into the soil until the mount plate is flush with the paver surface). These paver mounts take advantage of the friction and tension provided by the paver drilled into as well as all the surrounding pavers. Once installed into a paver patio/deck surface that is in good repair without significant gaps between pavers, the mount is impossible to move left, right, forward, back, can't twist, and angular forces are compensated for with the two pins and the adjacent pavers....the only way to remove it is to lift perfectly straight upwards.
LIMITATIONS: Due to the nature of this mount it is best suited to use with the Bahu Brand Angled Umbrella Bracket, Poolside Volleyball Posts (coming soon), and other accessories. This mount style will not work with the Bahu Brand Patio Umbrella brackets as an updraft will potentially pull the mount from the paver.
The Solid Surface Mount Style is used on concrete or similar solid surfaces. Installation requires 3 holes to be drill (drill bits provided) each of which then has an anchor inserted into the hole, followed by screwing in the provided machine screws.
LIMITATIONS: There are no restriction for use with this style of mount when properly installed and anchored.
A drill is required, but the kit comes with needed masonry drill bits to drill holes, and all necessary hardware. With the mount plate installed, the Angled Umbrella Bracket is simply inserted into the "keyhole" then rotated to desired position prior to locking in place with the provided pin and the thumbscrew.
Once installed the mount plate sits just 3/8" above the paver for a low profile, step over, step on, low hazard mount.